FX2S mezzanine config not supported

Question

I have a FX2S with a FD332, 2x FC640, each node has an Intel x710 quad NDC (Y348Y) and fibre channel mezzanine card (KHKN5), I dont plan to use any FC, I have ordered FN410S to replace the 1gb passthrough IO modules.

At the moment I keep getting this error:
UEFI0068: The mezzanine card configuration used is not supported on this chassis.

I have removed and tried booting without, and re-seated the mezzanine cards. updated all bios/drac/cmc, and reset to factory defaults all, still same. I can continue past this and OS and networking all work fine.

DELL-Chris H · Answer

Mcrholdings,

Normally I think this occurs when you are using a mezzanine that is not interfacing anything between the sled and the switch. Regardless though, you should be able to access the BIOS, then under Integrated Devices - Mezzanine Slot Disablement you can disable that mezzanine.

Let me know if this helps.

mcrholdings · Answer

@DELL-Chris H ​ I am familiar with that setting on R740, but that is not available on the FC640-

PowerEdge Hardware General

FX2S mezzanine config not supported

Was this post helpful?