Unsolved
This post is more than 5 years old
1 Message
0
442
August 10th, 2016 15:00
Poweredge T410- Fatal Bus Errors
Poweredge T410 keeps shutting off and not seeing the Raid controller until I reseat it. DSET show no issues with the controller or hard drives, but shows many fatal errors in the ESM Log. A bus fatal error was detected on a component at slot 4. A bus fatal error was detected on a component at bus 0 device 3 function 0. Please advise.
No Events found!
Daniel My
10 Elder
•
6.2K Posts
0
August 11th, 2016 11:00
Hello
The issue could be with anything in the RAID chain. It could be the slot, controller, a cable, or any drive attached to the controller. I would start by making sure the controller firmware and driver are up to date. If the issue persists then I would move the controller to slot 5. If the issue still persists then you will need to start disconnecting hardware to isolate the fault.
Thanks