Unsolved
This post is more than 5 years old
1 Message
0
2682
March 18th, 2017 12:00
PE 1950 - e1215 1.8v pwrgd
Hello,
My 1950 may finally be dying. It is auto rebooting and the error on the LED is e1215 1.8v pwrgd failed. Where is this part located? I have a 2950 sitting here that I can steal parts from. Help!
No Events found!
Daniel My
10 Elder
•
6.2K Posts
0
March 18th, 2017 15:00
Hello
The error doesn't refer to a specific part. It indicates that the 1.8v power good signal is outside the allowable tolerance range. This is an issue with the power subsystem that could be caused by several parts. I would suggest starting with easy to swap parts like the power supplies. Test with one PSU at a time. The power distribution board and all other power related components should be integrated into the system board. The system board would be the next likely component.
Since power issues can be caused by almost any hardware attached to the system you should also disconnect/remove any unnecessary hardware and take the system to minimum-to-POST. If you need further assistance please call back in and discuss fee-based options.
Thanks