1 Rookie
•
4 Posts
0
4720
March 22nd, 2021 15:00
unable to connect DELL S4112T to CISCO C9300 with interface breakout 10Gx4
Hi,
We would like to connect with one link 10G:
- DELL switch S4112T with QSFP+ 40GBASE-SR4
to
- CISCO switch C9300-24T with C9300-NM-8X module and SFP-10G-SR
The switches are connected with an MPO cable to 4 LC using fibers 1 and 12.
The DELL switch (version Version 10.4.3.4) is configured with:
- interface breakout 1/1/15 map 10g-4x
The DELL switch receives the signal from the CISCO switch.
The CISCO switch does not receive a signal.
The link does not work.
Any assistance is greatly appreciated.
Thanks
No Events found!
mchasset
1 Rookie
•
4 Posts
0
March 30th, 2021 09:00
Hi Marco,
this command is also unrecognized.
I solved my problem with the following command:
allow unsupported-transceiver.
thank you for your help
Marc
DELL-Josh Cr
Moderator
•
9.2K Posts
0
March 23rd, 2021 09:00
Hi mchasset,
Have you set the port group profile? https://dell.to/3lJpst3
mchasset
1 Rookie
•
4 Posts
0
March 29th, 2021 00:00
Hi,
we cannot set port group profile:
ONET024# show port-group
% Error: Unrecognized command.
ONET024#
ONET024# show version
Dell EMC Networking OS10-Enterprise
Copyright (c) 1999-2019 by Dell Inc. All Rights Reserved.
OS Version: 10.4.3.4
Build Version: 10.4.3.4.213
Build Time: 2019-06-10T09:54:17-0700
System Type: S4112T-ON
Architecture: x86_64
Up Time: 6 days 09:49:35
regards
DELL-Marco B
Moderator
•
3.8K Posts
0
March 29th, 2021 03:00
hi i will check the error and let you kjow
thanks marco
DELL-Marco B
Moderator
•
3.8K Posts
0
March 29th, 2021 08:00
Can you try show switch-port-profile page 180 https://dell.to/31HvKQZ
mchasset
1 Rookie
•
4 Posts
0
March 30th, 2021 00:00
Hi Marco,
this command is not recognized.
Is this a hardware compatibility issue?
ONET024# show switch-port-profile 1/1
% Error: Unrecognized command.
ONET024#
ONET024# show s
sessions sflow snmp
spanning-tree startup-configuration storm-control
support-assist switch-operating-mode system
ONET024# show s
% Error: Ambiguous command.
regards
DELL-Marco B
Moderator
•
3.8K Posts
0
March 30th, 2021 03:00
Hello,
can you try the command without "show" ?
https://dell.to/3sCBVRQ
Thanks
Marco