SM Fiber 10g Connection issues

I am trying to connect a new SM fiber run from one building to another with my Dell C9010 L3 to a Unifi USW Pro and I am running into a RX error on the unifi switch not allowing it to connect. Does anyone see any issues in the Dell config?

TenGigabitEthernet 1/7 is up, line protocol is down
Description: SOE_New
Hardware is DellEMCEth, address is d8:9e:f3:bc:71:42
Current address is d8:9e:f3:bc:71:42
Non-qualified pluggable media present, SFP+ type is 10GBASE-LR
Medium rate is unknown, Wavelength is 1310nm
SFP+ receive power reading is -40.0000dBm
SFP+ transmit power reading is -3.1560dBm
Interface index is 2098052
Internet address is not set
Mode of IPv4 Address Assignment : NONE
DHCP Client-ID :d89ef3bc7142
MTU 1554 bytes, IP MTU 1500 bytes
LineSpeed auto
Flowcontrol rx off tx off
ARP type: ARPA, ARP Timeout 04:00:00
Last clearing of "show interface" counters 1d23h32m
Queueing strategy: fifo
Input Statistics:
0 packets, 0 bytes
0 64-byte pkts, 0 over 64-byte pkts, 0 over 127-byte pkts
0 over 255-byte pkts, 0 over 511-byte pkts, 0 over 1023-byte pkts
0 Multicasts, 0 Broadcasts, 0 Unicasts
0 runts, 0 giants, 0 throttles
0 CRC, 0 overrun, 0 discarded
Output Statistics:
0 packets, 0 bytes, 0 underruns
0 64-byte pkts, 0 over 64-byte pkts, 0 over 127-byte pkts
0 over 255-byte pkts, 0 over 511-byte pkts, 0 over 1023-byte pkts
0 Multicasts, 0 Broadcasts, 0 Unicasts
0 throttles, 0 discarded, 0 collisions, 0 wreddrops
Rate info (interval 299 seconds):
Input 00.00 Mbits/sec, 0 packets/sec, 0.00% of line-rate
Output 00.00 Mbits/sec, 0 packets/sec, 0.00% of line-rate
Time since last interface status change: 89w4d17h