Unsolved
1 Rookie
•
1 Message
0
265
September 11th, 2022 22:00
Replacing a switch in a VLT domain
Hi, I am new to Dell Switches and need some clarity.
SW 2 in a VLT setup crashed and has to be replaced. And there were no backup configs. VRRP was not configured, so when SW2 rejoins the VLT domain, how does the IP Addressing work for the VLANs without VRRP? Cause I have this error when I check for VLT mismatches
VLAN L3-IPv4 mismatch:
VLT Unit ID Mismatch VLAN List
----------------------------------------------------------------------------
* 1 -
2 4, 7, 8, 9
No Events found!
DELL-Erman O
Moderator
•
2.8K Posts
0
September 12th, 2022 03:00
Hi, IP addresses can be assigned to VLANs when routing is desired. Actually, an IP address is not required for VLAN to work. VLANs are Layer 2 technologies that separate networks without assigning IP addresses to the VLANs themselves.
I don't know the model of your switch and which FW it uses, but maybe these links can help.
show vlt mismatch https://dell.to/3Bz3ouK -02c4-4537-ba70-12f6eadc9c12&lang=en-us
Dell EMC Networking OS10 How to set up Virtual Link Trunking (VLT) https://dell.to/3RR1laG virtual-link-trunking-vlt
Hope that helps!