Start a Conversation

Unsolved

S2

3 Posts

114

September 1st, 2022 13:00

Newbie configuring Powrconnrct 6224

Hi, new to world of powerconnect switching, hoping this is easy to answer. I’m trying to setup a test lab, to mimic my Cisco switch test lab. I.e. switch connects to router, obtains via dhcp an ip, put switch in l3 mode; create vlans, assign svi to vlans and route to router via gateway and inferred default route.

this works fine on a Cisco; if I want more I simply connect my switch to the router, setup a vlan, and then set my default router to my firewall.

yet I’m struggling with This on the powerconnect - the default dhcp acquired address is only for management. If I assign another vlan to the same range and use an access port to the firewall, it gives me an error. If I setup a vlan, add a server via a port, I can ping the svi, but a default route statement does not work, and I can.g ping the router. 

any advise would be greatly appreciated.

Ta,

Si

Moderator

 • 

5.1K Posts

September 1st, 2022 21:00

Hi, I hope this helps: https://dell.to/3TzFsON
Page# 726

No Events found!

Top