Start a Conversation

Unsolved

Closed

M

1 Message

1209

May 24th, 2023 12:00

Ethernet 1/1/35 is up, line protocol is down with SFP 1G OS10

Hello All,

Please i need you assitance if anyone had the same situation ,i have pluuged one Cisco SFP 1G on the the switch (Dell s4148f-on) the problem is the its always showing that the Pluggable media present, SFP+ type is SFP+ 10GBASE-SR,and the line protocol is down, here is the show interface result 

SW-DMZP1# show interface ethernet 1/1/37
Ethernet 1/1/37 is up, line protocol is down
Hardware is Eth, address is 4c:d9:8f:de:f2:d8
Current address is 4c:d9:8f:de:f2:d8
Pluggable media present, SFP+ type is SFP+ 10GBASE-SR
Wavelength is 850
Interface index is 51
Internet address is not set
Mode of IPv4 Address Assignment: not set
Interface IPv6 oper status: Disabled
MTU 1532 bytes, IP MTU 1500 bytes
LineSpeed 0, Auto-Negotiation off
Flowcontrol rx on tx off
ARP type: ARPA, ARP Timeout: 60
Last clearing of "show interface" counters: 2 weeks 5 days 04:22:47
Queuing strategy: fifo
Input statistics:
0 packets, 0 octets
0 64-byte pkts, 0 over 64-byte pkts, 0 over 127-byte pkts
0 over 255-byte pkts, 0 over 511-byte pkts, 0 over 1023-byte pkts
0 Multicasts, 0 Broadcasts, 0 Unicasts
0 runts, 0 giants, 0 throttles
0 CRC, 0 overrun, 0 discarded
Output statistics:
0 packets, 0 octets
0 64-byte pkts, 0 over 64-byte pkts, 0 over 127-byte pkts
0 over 255-byte pkts, 0 over 511-byte pkts, 0 over 1023-byte pkts
0 Multicasts, 0 Broadcasts, 0 Unicasts
0 throttles, 0 discarded, 0 Collisions, wred drops
Rate Info(interval 30 seconds):
Input 0 Mbits/sec, 0 packets/sec, 0% of line rate
Output 0 Mbits/sec, 0 packets/sec, 0% of line rate
Time since last interface status change: 2 weeks 5 days 04:22:47

Moderator

 • 

5.1K Posts

May 24th, 2023 18:00

Hello thanks for choosing Dell.

 

os10# 
os10# configure terminal
os10(config)# allow unsupported-transceiver
os10(config)# unlock third-party transceiver
os10(config)# end
os10# write 

 

Hope this helps.

No Events found!

Top