Unsolved
2 Posts
0
110
June 14th, 2023 21:00
DELL EMC S3048 Router issues with eth1 going down and not up
We have a DELL EMC S3048 Router and its giving a lot of issues to configure. We followed all these steps you outlined in the configuration documentation but we keep getting eth1 going down (not working). The eth0 returns ip address but the eth1 does not and its always showing its down. Even when we assigned an ip address to eth1, and it accepted, but will not go further to allow image to be copied on it or installed. How could we solve this problem. Can you explain please.
No Events found!
DELL-Erman O
Moderator
•
2.8K Posts
0
June 15th, 2023 02:00
Hello, Could try some steps to check eth1 port, several reasons might be causing that. First thing please cheeck the cable for any loose or damaged. Also, check the port for any physical issues. And please ensure your configuration matches for eth1.
If there is a firmware update please consider to update that might fix it.
femitenors
2 Posts
0
June 15th, 2023 08:00
Hello Erman, thanks for the answer, but the interface is not up at all. The Router is just being configured. No one is sure if has been configured before but we want to do it from scratch again installing ONIE OS. We can only get the Eth0 up, but not eth1. All videos we got online shows eth0 only coming up, but our comes with both eth0 and eth1 while attempting to boot in and install ONIE OS
DELL-Chris H
Moderator
•
9.4K Posts
0
June 15th, 2023 09:00
We would definetly need some additional details. Would you confirm a couple things for me?
I would ask how you are connected to the ports? As well as how far are you getting with the install itself?
Let us know.