Unsolved
2 Posts
0
267
July 27th, 2023 21:00
Configure Dell 2848 Switch SNMP not working
hi,
I have a customer that is using dell powerconnect 2848 switch and we are trying to configure SNMP for monitoring
my SNMP/Monitoring Admin said that he is able to ping the Switch IP but does not have any response when he does an SNMP-Walk. i can also see from the firewall that the traffic is allowed but i see that there is no reply from the device for SNMP. i have done the below SNMP configurations on the switch. is there any settings that i might have missed out?
is it possible to check the route table on the switch ?
Thank you for the replies and responses
Jeremy
No Events found!
DELL-Erman O
Moderator
•
2.8K Posts
0
July 28th, 2023 02:00
Hi, I assume the switch and SNMP/Monitoring Admin are on the same network and subnet. Please check firmware up to date and install MIB.(the firmware file has the MIBs included) Also I'm leaving this guide I think it is useful https://dell.to/3OxX2SZ
jtescanuela
2 Posts
0
July 30th, 2023 17:00
Hi Erman,
thanks for the response,
the switch and the snmp admin is on a different network. switch mgmt is on 192.168.x.x while the snmp admin is on 192.169.x.x
DELL-Young E
Moderator
•
5.2K Posts
0
July 30th, 2023 20:00
Hello the community string you configured is not supported, please see this.
https://dell.to/457T09f
page# 74