1 Rookie
•
2 Posts
0
120
February 8th, 2026 02:29
Latitude E5470 didn't boot after an SSD replacement(Sorry if my english isn't that good)
My win 10 laptop originally uses a Vaseky V820/256G (a SATA M.2 SSD) ,let call it ssd1. I wanna upgrade it so I choose a PQ3480 512GB (an M.2 NMVE SSD) (ssd2). I cloned my ssd1 into the ssd2 using Macrium on a booted Win environment(Anhdv boot).After that,I replaced ssd1 with my ssd2.I booted it and it showed win logo then run automatic repair then get stucked at the "Attempt Repairs" for roughly 20-30 mins.I turned it off manually by holding down the power button for a bit.Then I tried fixing the boot problem by going into the BIOS then changed the boot sequence to UEFI,RAID to AHCI also using apps on the boot usb that I talked about before like Macrium,DiskGenius,Dism ++,... but now the laptop only showed "No boot device found".Now Im stuck trying to troubleshooting this.Again,sorry if someone has problem understanding my this:P
Phung N.G
1 Rookie
•
2 Posts
0
February 8th, 2026 05:13
update:I finally fixed it and the laptop successfully booted.
-So I delete the old 500MB partition(the one that laptop uses to boot).And create a new one but with a new format(EFI system... or sth like that) using disk genius .After that,I opened cmd and used bcdboot to create a new boot.Then opened dism ++ and load in some new drivers in stornvme (built-in win driver in system32).-I restarted my laptop but it still gave me an error code(atleast not the "no boot device found") .I pressed f8 then booted into safe mode,log in and wait for like 5 mins.
-Then i restarted the laptop again and it's successfully loaded up.
First time doing this kind of upgrade since im just a grade 10 student rn:V btw have a great day:D