This post is more than 5 years old
2 Intern
•
217 Posts
0
1517
September 15th, 2009 06:00
turn on the ¿D¿ bit on the FA.
Do I need to make the FA offline to set the D bit?
No Events found!
This post is more than 5 years old
2 Intern
•
217 Posts
0
1517
September 15th, 2009 06:00
Top
xe2sdc
2 Intern
•
2.8K Posts
0
September 15th, 2009 06:00
symconfigure will FAST-IML the port if needed (but you won't notice a fast-IML with properly configured timeouts on your hosts).
modaslam
2 Intern
•
217 Posts
0
September 15th, 2009 07:00
dynamox
9 Legend
•
20.4K Posts
0
September 15th, 2009 07:00
xe2sdc
2 Intern
•
2.8K Posts
0
September 15th, 2009 07:00
IML is the internal name for "reboot". When you change the binfile the box will issue a "fast reboot" of all processors since they have to "rediscover" the new (changed) configuration.
IML = Initial Memory/Microcode Load
modaslam
2 Intern
•
217 Posts
0
September 15th, 2009 10:00
modaslam
2 Intern
•
217 Posts
0
September 15th, 2009 11:00
dynamox
9 Legend
•
20.4K Posts
1
September 15th, 2009 11:00
mcowger1
5 Posts
0
September 21st, 2009 17:00
notice it.
Hosts doing active IO most certainly do notice it - at least all of mine do!
xe2sdc
2 Intern
•
2.8K Posts
0
September 22nd, 2009 02:00
If your host notices fast IMLs probably the driver isn't properly configured.
What do you mean by "all of mine do"? What happens when a storage port reboots ?? What OS are you talking about ??
dynamox
9 Legend
•
20.4K Posts
0
May 20th, 2010 07:00
All recommendations I’ve seen say to reboot the box after enabling flags on the FAs. You can enable that flag just for the hosts the really need it ..using symmask hba_flag command ..but you still need to bounce the box.
rockman881
15 Posts
0
May 20th, 2010 07:00
I have several Red Hat Linux hosts that are currently connected to the San but we forgot to set the D bit on the Fa.
What is the impact to the hosts if I enable it on the Fa's after the fact? Do I have to shutdown the servers to make this change?