question about assign disk to a Sun Solaris server using Emulex HBA

I think you are looking at the LUN ID. if not, then you can assign those addresses to luns.(refer above link for more info)

this command gives you lun addresses available on perticular dir.

# symcfg -sid 123 -dir 3c -p 0 -available -address list

If you still feel you need to change the lun address the host sees here are some options:

http://forums.emc.com/forums/thread.jspa?messageID=593463򐸷

Message was edited by: KCSCLP per request of author, removed first paragraph.
KCSCP

Solaris hosts using the sd driver *are* limited to a maximum LUN address of 255.

MarcT: you are absolutely correct and re-reading my last post it was extremely misleading. I would like to edit it but cannot seem to do so.

Moderator: In order to avoid confusing anyone any further could you please edit my previous post in this thread and remove the first paragraph and just leave the pointer towards the lun addressing thread. In this case that thread should help this user get their storage allocated and visible to this server.

Sorry about that.

Just a few minutes before I've been able to react !!

Congrats CP

This thread will land at a better location (Host software/Open Systems) within a few seconds ... fasten your seat belts