Unsolved
This post is more than 5 years old
1 Rookie
•
2 Posts
0
3755
August 26th, 2011 09:00
Unable to restore image
I have a SBS 2011 installation on a PE T110 with two 250 Gb SATA (AHCI enabled) drives in a mirrored array. The disks are dynamic in the OS, mirrored via the OS. I have taken a full backup image using the native Windows backup utility to a USB external hard drive.
I then brought the server down and replaced the drives with two new drives, fired up the machine using the SBS 2011 install disk and selected 'Repair'. The restore progressed to about 75% of the way through before a received a message "The file was not found ". I assume this to be a driver needed.
Any thoughts/suggestions as to how I might get around this one?
TIA
Shobosh
I then brought the server down and replaced the drives with two new drives, fired up the machine using the SBS 2011 install disk and selected 'Repair'. The restore progressed to about 75% of the way through before a received a message "The file was not found ". I assume this to be a driver needed.
Any thoughts/suggestions as to how I might get around this one?
TIA
Shobosh
No Events found!