Dell EqualLogic 6010 Initial Setup

Hi. I have a Dell EqualLogic 6010 collecting dust in my test lab. It was sent from another office for unknown reasons. I would like to utilize this device to offload some developmental vm backup copies from our san to this smaller 16 drive device.  I only have one switch that came with it, but for the intended use, this should be fine. I will only be connecting one physical server to it where my back up software resides. (I wish I could simply direct connect, but I've read this isn't possible, or at least not recommended) The problem here is...I don't know where to start.

I have searched for set up guides, configuration guides, and manuals, but the only pdf's I find are more about limitations, best practices, what it can do, etc., rather than beginning from step one. (like, the directions that include setting up the rails and all that stuff we usually skip...lol) Can anyone help with a quick set up guide or crash course? Perhaps point me in the direction of some documentation? 

For example...do I serial in? If so, what are the default creds? Perhaps there's a default ip that I can connect my laptop to in order to begin initial set up? Or is there a config that I can run on the same subnet like EMC's VNX set up that will find unconfigured devices? I really can't find any of this set up info for this device. Hope someone can help. 

Thanks much. :)