Unsolved
9 Posts
0
623
February 20th, 2020 13:00
Static route on PS6100
Hi,
I am planning a temporary setup while I transition a client from a single subnet PS series to a dual-subnet configuration for an EMC unity. The new hosts will have IP addresses on the 2 new subnets but need to access the old storage.
Given I have 2 new independent switches with new subnets behind them, is there a way to configure static routes on the PS?
No Events found!
dwilliam62
4 Operator
•
1.5K Posts
0
February 20th, 2020 15:00
Hello,
No, there is not. Your default gateway is where you should make the routing changes.
If you are putting the EMC on two new subnets with their own NICs why can't you keep the old NICs on the EQL subnet until you migrate data off?
Regards,
Don