Unsolved
This post is more than 5 years old
17 Posts
0
1721
May 12th, 2017 14:00
PS6100 replaced controller due to C2F error. Now controllers stop responding during move?
had a controller 0 error with C2F battery issue. pulled out the SD card and replaced the controller 3 days ago, and ran some testing. new controller was on 7.1.14 and controller 1 was on 7.1.5. So i upgraded to 7.1.5. The other member of the group has both controllers still on 7.1.5.
During the move from maintenance group, back into production, there appears to have been an issue with the one, or both, controllers "not installed" and it ended up taking down all our VMs that were running at the time. After digging into this, i decided to move the member back into maintenance pool, and now I have seen the same errors from both controllers again??
Any ideas? could this be a known issue with this version of firmware when moving the member?
rhallmcp
17 Posts
0
May 13th, 2017 09:00
we use hyper-v in a failover cluster, with 2 equalogic members in the group.
I just upgraded the firmware on all of our arrays this morning to 8.1.8, so i hope that may resolve any issues that i was having.
I bought the controller from a company that repairs the c2f error. Iscsistuff is the name