This post is more than 5 years old
4 Posts
0
1847
September 12th, 2017 08:00
MEM 1.5 Issue Updating using VUM
Has anyone run into an issue installing MEM 1.5 on ESXi 6 using VUM? It seems the ESXi host will no longer boot with a generic "OS not bootable message". It is running on a Dell PER630.
Anyone seen this or have a suggestion to get the host to boot before I make the drive to this remote site to investigate?
Thanks.
No Events found!
mtucker299
4 Posts
0
September 14th, 2017 12:00
So after a rebuild and creating a baseline for Host Extension, all is working.
mtucker299
4 Posts
0
September 12th, 2017 08:00
Don,
Thanks for the reply. I would not have thought so either.
I rebooted the host and once it came back up, I imported the MEM 1.5 update and applied using VUM. Once the host rebooted a second time, it failed to boot into esx. It doesn't even attempt to load (never gets out of the BIOS) so I am not sure what happened.
Thanks again.
mtucker299
4 Posts
0
September 12th, 2017 09:00
I just figured out the issue. When the patch baseline was created (sometime ago) it was created as a host PATCH and not EXTENSION. I had not used that baseline before.
So its off to rebuild this host...