Unsolved
1 Rookie
•
39 Posts
0
712
May 5th, 2020 01:00
Equallogic PS4110XV
Hi All,
i have a type 12 controller that shipped without an SD card in it - i have found which fw was on it and cloned an SD card. However when i put that SD card into the controller i get this:
.a2d_handler: error on i2c write of config reg, status = 5
is this an issue with the 'clone firmware'?
No Events found!
dwilliam62
4 Operator
•
1.5K Posts
0
May 5th, 2020 05:00
Hello,
It's not a lot of info to go on, but that's seems likely.
Did you try the source CF card as well? Also what size is the CF card you installed?
Where int he boot process do you see that message? I am presuming you are attached to the serial port of that controller?
Regards,
Don