Unsolved
This post is more than 5 years old
4 Posts
0
1732
July 19th, 2016 22:00
EqualLogic PS4000 EX HD fail and replace
Dear Experts,
I am using Server DELL EqualLogic PS4000 EX. Recently i make replacement a faulty HD. Server show that new HD status is Spare. However its light is off, but not green. I am wondering new HD is working or not. The only difference is that new HD have different firmware from the other.
Thanks a lot in advanced for any help or support.
No Events found!
hung.nguyen
4 Posts
0
July 20th, 2016 19:00
Dear Donald Wi,
Thank you a lot for your advice. The picture of GUI shown above. Does this say that new replacement is working ?
hung.nguyen
4 Posts
0
July 21st, 2016 01:00
Thank you for your kindly help.
Is this possible to make it spun up and light turn ON whereas It still work as spare.
Can we be sure that this HD will work in case one other HD get fail ?
Best regards,
hung.nguyen
4 Posts
0
July 22nd, 2016 03:00
Dear DONALD WI,
Thank a lot for your advice.
So far, as your advice then my new HD replacement is normal and it will working when one of other HD get fail. When i asked guys at DELL Vietnam, they also said some thing like that. However i would like to be sure that from expert like you.
Thanks again for your kindly help.
Best regards,