Unsolved
This post is more than 5 years old
1 Message
0
595
September 19th, 2018 06:00
Add Equallogic Group to Network
We shut down a data center and are moving our 6110x & 6110E SANs back to our corporate office to add to our current network. How do I change the IP address to get the Equallogic SAN headquarters to see the group?
It was set up with a different subnet and gateway.
Can't seem to figure it out.
Thank you in advance
Chris Rodgers
No Events found!
dwilliam62
4 Operator
•
1.5K Posts
0
September 19th, 2018 07:00
Hello Chris,
Please see this forum posting it shows on a PS4110M but that is same procedure for PS6110
https://www.dell.com/community/EqualLogic/Changing-Equallogic-blade-Array-PS-M4110-IP-Addresses/m-p/6068428
Regards,
Don