Unsolved
This post is more than 5 years old
67 Posts
0
1596
February 24th, 2011 08:00
Powerpath setup for Solaris 10 Local and Global zones
Hi,
We are trying to setup devices for Solaris 10 with local and global zones. There are no/few info about how to install/config Powerpath. If you are already using PP with similar enviroment, I would be greatful to hear how and where you installed it and configured the devices. TIA.
Maduro
gc_emc
45 Posts
0
April 22nd, 2011 06:00
Hi ,
The EMC PowerPath® pseudo devices (emcpower) can be exported to non-global zones. Instructions on how to export emcpower devices
to non-global zones is provided in the PowerPath 5.x Installation andAdministration Guide, available on Powerlink
CAUTION
EMC software applications (including Solution Enabler, PowerPath, Naviagent, etc.) are not supported for installation and
use in the non-global zone.
Refer to EMC Host Connectivity Guide for Oracle Solaris
The EMC PowerPath® pseudo devices (emcpower) can be exported to non-global zones. Instructions on how to export emcpower devices
to non-global zones is provided in the PowerPath 5.x Installation andAdministration Guide, available on Powerlink
CAUTION
EMC software applications (including Solution Enabler, PowerPath, Naviagent, etc.) are not supported for installation and
use in the non-global zone.
Refer to EMC Host Connectivity Guide for Oracle Solaris
Rdgs,
Gearóid