Unsolved
This post is more than 5 years old
1 Message
0
371
August 29th, 2017 03:00
R620 and IDRAC fail
Hi all,
I have a problem with a PowerEdge R620 server.
After an AC loss due to UPS failure, now the server every time is switched on display the message that the iDrac is not working and reboots...
After reboot if I confirm the boot with F1, the server load operating system and all is working but the system fun are at maximun speed with a lot of noise.
I think the iDrac card has gone, the LAN link is down but the switch port is OK.
Any suggestion ?
Many thanks....
Piero Baudino
No Events found!
PEOOWretired
2 Intern
•
207 Posts
0
August 29th, 2017 05:00
Dear Piero,
Thank you for contacting the dedicated Out of Warranty forum for PowerEdge products. We have sent you a private message on the forum in order to get the Service Tag of your PowerEdge Server.
Kind Regards,
Manjunath