Unsolved
This post is more than 5 years old
1 Rookie
•
1 Message
0
3190
August 1st, 2017 03:00
Configuring Static Routes
Hi,
I am trying to configure a static route on an ECS appliance. I have found the following white paper: https://www.emc.com/collateral/white-paper/h15718-ecs-networking-bp-wp.pdf and created a file ifroute-public.repl:
admin@provo-blue:/etc/sysconfig/network> cat ifroute-public.repl
192.168.0.0 10.240.223.100 255.255.255.0 public.repl
I've also run sudo service network restart and yet the route is not in the local host routing table:
admin@provo-blue:/etc/sysconfig/network> netstat -rn
Kernel IP routing table
Destination Gateway Genmask Flags MSS Window irtt Iface
0.0.0.0 10.241.172.1 0.0.0.0 UG 0 0 0 public
10.241.172.0 0.0.0.0 255.255.255.0 U 0 0 0 public
127.12.7.0 0.0.0.0 255.255.255.0 U 0 0 0 docker0
169.254.0.0 0.0.0.0 255.255.0.0 U 0 0 0 private.4
192.168.219.0 0.0.0.0 255.255.255.0 U 0 0 0 private
Could someone please let me know how I can add a persistent static route to an ECS appliance?
benschumacher
1 Rookie
•
75 Posts
0
August 7th, 2017 07:00
Can you try running this command after you complete modifying your ifroute-public.repl file: sudo systemctl restart wicked wickedd
Then, you can run: sudo wicked ifstatus public
That should tell you if the route persisted.
girijb
1 Message
0
June 27th, 2022 21:00
you can modify routes file under /etc/sysconfig/network/routes
sudo vi /etc/sysconfig/network/routes
172.15.3.33 172.15.6.1 255.255.255.255 - # adding static route, and a - in the end of the line
sudo service network reload # restart network service after adding static route
sudo netstat -rn # check your new static route