Unsolved
This post is more than 5 years old
1 Rookie
•
51 Posts
0
3732
May 31st, 2013 09:00
DELL AIO 2320
I have been messing with this thing till I am blue in the face. Motherboard is mounted to a metal panel and the lcd is mounted on the front of it. With it put together like it should be the power supply goes into safe mode. I can unscrew lcd where its not touching back metal panel and it works fine or I can put it back together and have the motherboard not touching panel and also works fine. I don't see any place under the motherboard that is touching but with motherboard mounted and lcd unhooked it stays running. My next step is add some rubber washer under the MB. Not sure where to go from here? Any Suggestions? Thanks Michael
No Events found!
osprey4
4 Operator
•
34.2K Posts
0
May 31st, 2013 10:00
Hi Michael,
I seem to remember trying to help you with this machine before. Don't remember. Anyway, I think you've got the problem diagnosed, and I would go with the washer solution if that fixes it. There are very thin non-metallic washers available for mounting electronics such as boards and such. You might want to try that.
Hornnumb2
1 Rookie
•
51 Posts
0
May 31st, 2013 18:00
I added the rubber washer to the board but as soon as you screw the heat sink through its back to safe mode.