Unsolved
This post is more than 5 years old
4 Posts
0
16316
November 9th, 2012 14:00
Mounting my Data from MD3200i on to Windows server 2008
Hi to all.
I have the MD3200i.
I have three disks at Raid 5 (total 5,588,038GB Free)
I have create virtual MAP and i want to mount this data storage on to my windows server.
How can i do this?
regards
No Events found!
gsiomos
4 Posts
0
November 9th, 2012 14:00
in which chapter i can find this?
i have done the mapping but i cannot find the way to make it vissible on to the windows management...
DELL-Sam L
Moderator
•
7.6K Posts
0
November 9th, 2012 14:00
Hello gsiomos,
Here is a link to the owner’s manual. If you look on page 95 it explains on how to connect a host to your MD3200i. ftp://ftp.dell.com/Manuals/all-products/esuprt_ser_stor_net/esuprt_powervault/powervault-md3200i_Owner%27s%20Manual_en-us.pdf
Let us know if have any other questions.
DELL-Sam L
Moderator
•
7.6K Posts
0
November 9th, 2012 15:00
Hello gsiomos,
If you look on page 129 it explains how to connect it to the host.
Let us know if have any other questions.
gsiomos
4 Posts
0
November 10th, 2012 11:00
Hi again..
i do all these steps, but i cannot see the data on my Disk Management at windows...
any help?
Dev Mgr
4 Operator
•
9.3K Posts
0
November 12th, 2012 08:00
Did you install MDSM (host software) on the host? Also; did you make the iSCSI connections from the host to the iSCSI ports on the array?
gsiomos
4 Posts
0
November 12th, 2012 13:00
Yes...
Today, i disconect everything and i done it from the beggining..
I have one Server. The server has 2 NICS.
1 is connected on to the iSCSI port...
The system see this NIC and i can configure the DELL..
The other CARD is connected to my network, (192.168.2.4) to share all the data from the server..
Is working now.
The wrong thing i was doing it was that i didn't connect the NIC to the iSCSI Network Port, but into the Management Network port...
Thanks a lot!