This post is more than 5 years old
8 Posts
0
26823
April 24th, 2015 08:00
ML6000 LCB replaced
I had a bad LCB and I have replaced it and have the system powered up again but I cant get the library to initialize. I do not have a back up. I need help please
No Events found!
DELL-Daniel Ca
243 Posts
0
April 24th, 2015 12:00
Hello, pettij.
If the LCB was purchased from a 3rd party source, it's quite possible it's looking for a serial number that it expects to find that isn't there.
A couple options available - 1. Flash the firmware to the latest, and 2. Reset to defaults.
Instructions for doing so can be found on page 38 of this document:
[View:/cfs-file/__key/communityserver-discussions-components-files/3412/6_2D00_01367_2D00_10_5F00_ML6000Maintenance-Guide.i8.2.pdf:38:41]
The firmware is available for download from: http://www.dell.com/support/home/us/en/19/product-support/product/powervault-ML6000/drivers
I hope this helps. Let me know if you have any further questions or concerns.
pettij
8 Posts
0
April 24th, 2015 08:00
I am getting a T128 Incompatible robot installed ticket
pettij
8 Posts
0
April 24th, 2015 13:00
That worked but I am now getting a WWN error