Unsolved
This post is more than 5 years old
3 Posts
0
8271
September 17th, 2008 22:00
EMC2 AX150 cant configure IP for second processor at initialization
Have both maintence ports connected with crossover cables directly to the PE 2950 that I intend to be the assigned server for the array. I see network traffic on both cables and yet when I discover it with Navisphere I can set the IP for storage processor A but not for B it is greyed out. I have reset the AX 150 twice and still cant get B to be configurable. And the guidlines on this forum say not to continue if you cant set the IP for both processors.
Can anyone help with this?
No Events found!
Dell-Jeff G
156 Posts
0
September 18th, 2008 12:00
Can the Init Tool find SPB if it is the only SP connented to with the crossover cable? If yes, connect the host to a switch and both SPA and SPB to the same switch, verify Link LEDs.
If no, are there any fault (or blinking LEDs) on SPB? SPB is on the left looking from the rear.
Both SPs need to be on the same subnet, so you will need to use a switch or hub to discover both SPs.