Unsolved
This post is more than 5 years old
1 Message
0
8073
October 15th, 2008 08:00
Dell PowerEdge 1955 and Brocade Switch
Hi-
I am connecting my Dell 1955 which has Mcdata Switch to my Existing SAN Switch which is Borcade. and i get the following error.
[1003.002F]Interop Zoning Not Supported by remote switch.
On searching the net i found out that this issue is due to the interop mode settings on the Switches. My Mcdata Switch has the Inetop Setting as standard while my Brocade switch has a setting in Brocade Mode.
So is there way by which i can connect the two fabrics without changing my settings on the existing Brocade Switch as it is in Production.
If i chnage the setting on the brocade to standard will it affect my existing setup.
No Events found!
Dev Mgr
4 Operator
•
9.3K Posts
0
October 15th, 2008 16:00
I don't believe this is possible.
To change the interop mode on a Brocade you have to disable the switch (killing all IO) and then change the interop mode. After this you re-enable the switch.
Obviously, prior to making any changes back up the config first, just in case.