Unsolved
This post is more than 5 years old
4 Posts
0
5203
December 8th, 2010 15:00
CX-300 Settings on my SPA/SPB properties - Fibre Speed?
On my CX-300 the Fibre Speed my Selected Speed is 1Gb for both ports on SPA/SPB but the Actual Speed is 2Gb - If I change the selected speed to 2GB will anything really change? And why doe it show Actual ar 2Gb if the Selected is 1Gb?
KG.
No Events found!
Dev Mgr
4 Operator
•
9.3K Posts
0
December 9th, 2010 06:00
This sounds like a Navisphere reporting issue.
I'd suggest the following steps:
- go to http://ip_of_SPA/setup
- log in
- look for the "Restart Management Server" (or something very close to that)
- select this option and confirm (note: this only restarts Navisphere and does not reboot the SP (some reservations here especially if you are running really old flare))
- wait a few minutes
- do the exact same steps for SPB
Now you check those settings and speed again. Most likely you'll see settings/info that make more sense.