This post is more than 5 years old
1 Rookie
•
33 Posts
0
288692
January 12th, 2013 04:00
Battery on Controller PERC 6/i integrated for Poweredge R900 and 2950.
Hi, we have this error below in Poweredge R900 and Poweredge 2950 for 4 days now, hopefully it will be gone after 7 days(as per Maximum learn delay)
Battery on Controller PERC 6/i integrated:
Name Battery 0
State Degraded
Predicted Capacity Status Ready
Learn State Due
Next Learn Time 0 hours
Maximum Learn Delay 7 days 0 hours
Learn Mode Auto
In case the error remains after 7 days, is there any other solution to this? or we need to replace the battery if error remains.
I had been searching for the correct part no. of the Battery so that we can order in advance, pls provide the Battery part no. for Poweredge R900 and 2950 controller PERC 6/i intergrated.
Thank you very much in advance.
regards
tommo666
1 Rookie
•
1.2K Posts
1
January 19th, 2013 02:00
Rais info is stored on the disks so should not be an issue
R900 page 84 support.dell.com/.../XK9460D.pdf
2950 page 74 support.dell.com/.../hom.pdf
tommo666
1 Rookie
•
1.2K Posts
0
January 14th, 2013 06:00
sounds like they're on the way out. Google 'dell nu209' for a replacement.
botod
1 Rookie
•
33 Posts
0
January 15th, 2013 01:00
Hi thanks...just a follow up question...when replacing the battery, i am worried about my raid configuration and the data, Are the raid configuration and data will still be intact when replacing the baterry???
Is there a way to back up the raid configuration??
thanks again...
botod
1 Rookie
•
33 Posts
0
January 15th, 2013 10:00
Hi ...one more thing do you have the procedure when replacing a battery of perc 6/i of poweredge 2950 and R900.
thanks again..
botod
1 Rookie
•
33 Posts
0
January 19th, 2013 04:00
Thank you very much for the info...