Unsolved
This post is more than 5 years old
13 Posts
0
23419
September 9th, 2013 00:00
centos support
hiii...
I have a Dell poweredge M1000e (blades 620) and i need to install CentOS 6.0 (based on Red Hat 6) ,But i couldn't install it through SBUU
the errror was " invalid os located " after check configuration for Red Hat 5.8 or 6.2
is there any additional configuration i have to do it to do that??
or is there any other version that suppurt Red Hat 6.0 and older??
No Events found!
azaer
13 Posts
0
September 9th, 2013 01:00
:emotion-7:
Dell-Kumaran P
42 Posts
1
September 9th, 2013 08:00
Azaer,
Please post your query in the PowerEdge OS forum to get a quick response.
The forum link is here:
http://en.community.dell.com/support-forums/servers/f/1466.aspx
K Sashi
87 Posts
1
September 10th, 2013 00:00
Hi,
SBUU does not support installation of CentOS.
You may try installing whatever is the latest Linux OS supported by SBUU i.e. RedHat 5.8 or 6.2 etc..
If you are looking for an older RedHat 6.0 version, you may need to use an older OM DVD which has that support.
Thanks,
Shashi.
azaer
13 Posts
0
September 10th, 2013 01:00
thanks for reply ..
but CentOS is based on RedHat and approximately the same !!
a_pratap_singh
1 Rookie
•
69 Posts
1
September 10th, 2013 01:00
Network driver is required for enabling the system NIC.
K Sashi
87 Posts
0
September 10th, 2013 01:00
Hi,
It will be as per the matrix defined. At present CentOS is not supported by SBUU.
Thanks,
Shashi.
azaer
13 Posts
0
September 10th, 2013 01:00
By the way , I tried to install CentOS without SBUU and it 's done. but the problem was that CentOS doesn't see the "pass througt NICs" and couldn't have an IP from "broadcom switch B1,2 M6220" !!!
thank you for care and sorry for not good English