Unsolved
This post is more than 5 years old
2 Posts
0
15081
August 11th, 2015 12:00
OME 2.0.1 and MD3000i issue
Hello!
I'm working on getting on MD3000i units to show properly in OME to keep tabs on alerts that come up. All of the troubleshooting tasks are checking out fine. I've configured the SNMP string on the SAN, and it's reporting back when i execute the Powervault test in the troubleshooter.
The units are showing up under Storage Devices -> Powervault MD Arrays but the health is unknown and there is very little further details.
Any help would be greatly appreciated.
Mike
No Events found!
DELL-Martijn G
291 Posts
0
August 12th, 2015 01:00
Make sure you have the Storage protocol enabled in the corresponding discovery range.
mselinger3
2 Posts
0
August 12th, 2015 10:00
Thanks for your reply. I do have that checked in the discovery job that is setup. There aren't too many variables so I'm not sure what else it could be. Still looking for a good resolution.
DELL-Martijn G
291 Posts
0
August 13th, 2015 01:00
Please take a look in the log after a discovery/inventory and see if there is anything in there.