This post is more than 5 years old
1 Rookie
•
33 Posts
0
1041
April 28th, 2013 22:00
Zone renaming issue in DCNM 6.1(2)
Hi
Below are the steps i used to rename a zoneset in CISCO DCNM 5.2.2. After renaming the zoneset( rightclick->Rename , change the name with new and press ENTER ) , while ACTIVATing the zone , this used to show like , removing a zoneset with old name, and adding a zoneset with new name with same members.
Recently DCNM upgraded to 6.1(2) and the same procedure is not working for renaming a zoneset. Renaming and ACTIVing doesn't show or make any changes for the zoneset.
Please let me know if you come across the same situation and found any solution.
thanks in advance
( please move to the correct forum if this not the correct one )
No Events found!
RajeshUnni
1 Rookie
•
33 Posts
0
May 21st, 2013 07:00
Upgrading DCNM to 6.2.1 resolved this issue.
christopher_ime
2K Posts
0
July 6th, 2013 03:00
rajeshvu,
Thanks for the update!
Please consider moving this question to the proper forum for maximum visibility. Questions written to the users' own "Discussions" space don't get the same amount of attention and questions can go unanswered for a long time. You can do so by selecting "Move" under ACTIONS along the right. Then search for and select: "Infrastructure Connectivity Support Forum" which would be the most relevant for this question.
Also, seeing that you had resolved it on your own, by relocating it to the proper community would benefit others that may have the same issue.