This post is more than 5 years old
1 Rookie
•
82 Posts
0
1366
February 12th, 2010 08:00
Path degradation after zoning.
We had a problem last night with zoning. Couldn't think of any reason that might have caused the issue. Really appreciated if someone could help me with some thoughts on it. Here is the problem:
A windows server (a)
Powerpath 5.3
Had disks from 'x' & 'y' symmtrix.
we Need to add disks from one more symmetrix 'z.
On San-01 we have following active zones
(a,x) &
(a,y)
Added One of the FA from symm 'z' in to the zone (a,y) to make it (a,y,z) --> for a migration purpose.
After activating the zoneset - we had no issues with paths to disk on 'y' symm but the paths to disks on symm 'x' degraded.
Could someone please help me with some thoughts on why did the paths to symm 'x' degraded.
We backed out of the change and everything was normal again.
healyj
141 Posts
0
November 28th, 2017 07:00
Hi there,
In our efforts to clean up the forum, we came across your question / statement.
If the question / statement is still valid, not expired and you need an update please reach out again and we try to get it answered.
As for now we set it to “answered.”
Regards,
Jim
dynamox
9 Legend
•
20.4K Posts
0
February 12th, 2010 08:00
AranH1
2.2K Posts
0
February 12th, 2010 09:00
Kushi2
1 Rookie
•
82 Posts
0
February 12th, 2010 09:00
We are planning to perform PPME-OR migration of the server from symm 'y' to 'z'. With EMC recommendations, we thought of having same zone for a, y & z.
Does this have anything to with HBA of the server? did HBA tried to reconnect to all the symms when we tried to activate the zone (a,y,z)??
SKT136306
31 Posts
0
February 13th, 2010 06:00