Unsolved
This post is more than 5 years old
1 Rookie
•
53 Posts
0
636
December 3rd, 2012 05:00
MDS issue after upgrade
I have upgraded the both switches from 5.0.4c to 5.2.2d but I have faced same issue on both after the upgradation. On switch two (secondary) fc2/33 port was shown initializing status and after the reboot switch two fc2/33 status was shown up. Also when I upgraded the switch one (Primary) and found fc2/47 port is now showing initializing status, Please advise.
No Events found!
Vipin VK
2 Intern
•
812 Posts
0
December 3rd, 2012 10:00
Hope it will be ok if you do a 'shut' and then a 'no shut' on the fc port.
MAwais
1 Rookie
•
53 Posts
0
December 3rd, 2012 10:00
I have done below steps but problem is still:-
1) shut and no shut
2) replace the SFP
Regards,
Mawais
felipon1
96 Posts
0
December 4th, 2012 01:00
Hi,
Please, paste the output of "show interface" command for the affected port.
What is connected to it?
Please check if Trunk mode ins currently 'on' for that port. If so, try disabling it.
Rgds