Unsolved
This post is more than 5 years old
1 Rookie
•
118 Posts
0
1480
May 6th, 2010 22:00
Adding HP blade servers to fabric
Hi Guys,
we will add these servers to the existing fabric :
Blade Servers : HP BL460c G6 X5550
HBA Cards : HP BLc QLogic QMH2562 8Gb FC Dual Port HBA
SAN Switch :
HP B-series 8/12c BladeSystem SAN Switch (Brocade), each:
- Full Fabric
- Brocade
- 8 ports internal, 4 ports external
- Each switch includes 2 x 8Gb Short wave transceiver for external ports
Does any one know the steps to connect the san switches on these blades to the fabrics which is 2 "B-48K" directors for each fabric we have.
thanks in advance
No Events found!
Mohammad_akkoub
1 Rookie
•
34 Posts
0
May 8th, 2010 13:00
Walla Ya man sheklo ma fe hada aref ?!
dynamox
9 Legend
•
20.4K Posts
0
May 16th, 2010 09:00
when it comes to connecting blade enclosure switches to existing fabric, the easiest way to do that it by enabling access gateway mode on the enclosure switches and NPIV mode on your core switches. You don't have to mess with fabric settings, increase your fabric size. Take a look at this document but also verify firmware/connectivity support in E-Lab Navigator
http://www.brocade.com/downloads/documents/technical_briefs/AG_NPIV_Quick_Config_GA-CG-059-00.pdf
vijay_gali
14 Posts
0
September 27th, 2010 22:00
Can any one help me How to Configure DS-300B 8/24P Base switch from the initialization stage.
Thanks
Vijay
dynamox
9 Legend
•
20.4K Posts
0
September 28th, 2010 03:00
Vijay,
welcome to the forums, can you please start a new thread.
Ayman_Talkhan
25 Posts
0
September 29th, 2010 01:00
Hello Vijay,
Welcome to the EMC support forums.
If possible could you please open a new thread for your question.
If you need assistance with this please let me know.
Have a great day,
Regards,
Ayman
vijay_gali
14 Posts
0
October 5th, 2010 01:00
Hi,
i have started new discussion
Thanks
Vijay