Unsolved
This post is more than 5 years old
14 Posts
0
784
May 24th, 2014 01:00
How to recover EMC VNX SP while OE upgrade process ends with errors.
Dear all,
I want to recover my EMC VNX SP because while I was upgrading the VNX through USM, the process finished with errors .
BR
No Events found!
M_Salem
213 Posts
0
May 26th, 2014 05:00
Hi Moaveni,
Thanks for contacting EMC Community.
Can you please send us screenhots for the issue you have?
Also include at which step the Upgrade failed and if both SPs are pingable or not.
Hope that helps
Mohammed Salem
Jyothi_P_Bharat
317 Posts
0
May 26th, 2014 05:00
Hi,
Could you please provide more details about the error message?
Thanks
Jyothi
kelleg
4.5K Posts
0
May 29th, 2014 08:00
Was your question answered correctly? If so, please remember to mark your question Answered when you get the correct answer and award points to the person providing the answer. This helps others searching for a similar issue.
glen
Moaveni
14 Posts
0
May 30th, 2014 07:00
Dear all,
thanks for support
I have no screen shot.
after success message appeared shown all pre requirements are ok about 11stages start to upgrade .
at general in any section it could be happen I mean upgrade process failure so there must be a way to recover SP.
I'm looking for documents or something link it to explain recovery SP procedure from typical conditions.
maybe from service port, maybe with NavisecCli.exe file or some utilities. I'll be appreciate for any help
Thanks
Br.