Unsolved
This post is more than 5 years old
54 Posts
0
569
August 26th, 2014 12:00
CX300 Flare Code Upgrade through single SP ?
San Admins,
Greetings!
We are in the middle of doing a FLARE code upgrade on a cx300 using just SPA while the SPB is faulty. We tried using the NST (Navisphere Service Taskbar) to deploy the code but during the pre-checks, it says "communication with SPB is lost" - cannot proceed further.
Do we really need both the SPs to be ACTIVE and functioning fine to proceed with the code upgrade ? We also tried to use the direct software deployment using NST without going through the pre-checks, but still the software load threw the same error.
Your kind suggestions please.
Taz~
No Events found!
Roger_Wu
4 Operator
•
4K Posts
0
August 26th, 2014 17:00
Yes, before the upgrade, NST will verify if all the components are Ok.
Anonymous User
375 Posts
0
August 26th, 2014 22:00
As far as I remember, it will first upgrade SPB & as Roger said that it first goes for health check.
Thanx
Rakesh
kelleg
4.5K Posts
0
September 8th, 2014 08:00
Was your question answered correctly? If so, please remember to mark your question Answered when you get the correct answer and award points to the person providing the answer. This helps others searching for a similar issue.
glen