This post is more than 5 years old
4 Posts
0
2776
January 20th, 2012 03:00
Linux shell commands to show Centera pool capacity
I am looking for Centera shell commands to be used in our Linux environment to view Centera pool capacity, i.e.., shell commands equivalent to the "show pool capacity" and "show capacity availability" that we currently use via Centera Viewer.
I have found in this site the download link for Linux Centera Tools 1.0 (https://community.emc.com/docs/DOC-8055). However I am not sure of the following:
- is it a supported Centera release?
- which of the claimed included packages (i.e. JCASScript 3.2.35 (GCC3.3), JCenteraVerify 3.2.23 (GCC3.3), CenteraPing 3.2.70 (GCC3.3), Centera interactive shell (Implementation CLI 4.1.2066, 2009-10-15)) would provide me what I need?
- where can I find the installation and user guide documentation?
Thank you very much for the support,
Michele Re
Satish_Kutty
216 Posts
0
January 27th, 2012 08:00
Hi Michele,
You can download the Centera CLI from Powerlink,the Link is given below,but not very sure about the Support for Shell command that you are looking for.
Home > Support > Software Downloads and Licensing > Downloads C > Centera Enterprise Software
Regards
Satish.N.Kutty
michele_re
4 Posts
0
February 3rd, 2012 09:00
Dear Satish,
on Powerlink I cannot find any CLI download link: I can only download the Console and the Backup&Recovery modules. Any help? Additionally, do the Centera CLI run also on Linux?
Thanks a lot for your support,
Michele
Satish_Kutty
216 Posts
0
February 9th, 2012 10:00
Hi Michele,
Do apologize for the delay in response. I believe that you might have permission issues with Powerlink.Please send an email to powerlink@emc.com they should be able to resolve the issue permanently. We do have Centera CLI version for Solaris but not for Linux exclusively.
Regards
Satish.N.Kutty