Start a Conversation

This post is more than 5 years old

Solved!

Go to Solution

526

June 9th, 2008 23:00

Configuring EA Standby

Need to configure a node a standby node for CUA 4.4

Right now I have one CUA node that is currently functioning properly and I have one node that is currently only with CUA 4.4 level. Need to proceed with configuring it as a CUA EA node. I understand the settings and procedure generator however I am interested if I have to manually enter all the access profiles, all directories and all that information manually or will it get these settings after I point a standby node in the configuration menu.

Please assist

19 Posts

June 11th, 2008 07:00

EA should be configured by EMC personnel. You would have to configure the initial settings to get it on the network and then the access profile(s). Everything else will be picked up from the restore the standby does when it's initially configured.

Steve

Message was edited by:
Steven Ruo

82 Posts

June 10th, 2008 23:00

anyone?
No Events found!

Top