This post is more than 5 years old
14 Posts
0
1466
July 25th, 2012 10:00
Which version of DART supports IPv6?
Hi All,
I have the following questions -
- Which version of DART supports IPv6?
- Can I configure IPv4 & IPv6 IP in a Celerra Control Station?
- Does Celerra support NAS clients with IPv4 and/or IPv6 IP address?
Thanks,
Sushobhan
No Events found!
Rainer_EMC
4 Operator
•
8.6K Posts
0
July 26th, 2012 00:00
Release notes and manuals are on support.emc.com
The Configuring and Managing Networking on VNX has information about IPv6
VNX supports both IPv4 and IPv6 simultaneously by means of a dual IPv4/IPv6 protocol
stack. Applications that support either IPv4 or IPv6 can run on the same network.
Rainer_EMC
4 Operator
•
8.6K Posts
0
July 25th, 2012 12:00
Yes, the current release support Ipv6 – for some restrictions see the release notes
sushobhan
14 Posts
0
July 25th, 2012 23:00
Please elaborate. Are you talking about VNX by 'current release'? Where do I get release note?
Thanks/Sushobhan
kajibade
33 Posts
1
August 13th, 2012 05:00
That is correct.
IPv6 is not supported any v5.x.x version of DART.
sushobhan
14 Posts
0
August 13th, 2012 05:00
Thanks all for the info. I got the answers I was looking for.
Regards,
Sushobhan
sushobhan
14 Posts
0
August 13th, 2012 05:00
Hi All,
Sorry, I got distracted by something else and got time to look at this just now.
So...IPv6 is not supported any v5.x.x version of DART?
Regards,
Sushobhan