Unsolved
This post is more than 5 years old
22 Posts
0
4637
October 15th, 2018 08:00
Unable to connect to VNX5300 SPA or SPB using USM?
The error messages says "The specified system is not reachable or the certificate on the system could not be validated."
I can connect to the VNX through Unisphere...
I get the same issue with all of my VNXs.
Block OE ver 5.32.000.5.204
and my old 5.31.x
USM ver 1.3.9
No Events found!
cdntekkie
22 Posts
0
October 16th, 2018 05:00
I should note that these SPs were part of a unified system. The control unit is gone but they still work for block stuff fine, just want to put some enablers on.
Rainer_EMC
4 Operator
•
8.6K Posts
0
October 18th, 2018 05:00
can you acess them using Unisphere or navicli ?
cdntekkie
22 Posts
0
October 21st, 2018 09:00
Yes, I can bring up unisphere and I can access via the navicli.