Unsolved
This post is more than 5 years old
5 Posts
0
524
November 5th, 2012 08:00
ndmpcopy with level 1
I need some assistance with an issue we have over here. We are running ndmpcopy with a level 1 and it's been running for about 3 hours. We are sure nothing changed over the weekend too much on this filesystem. This network is not used very much so a level 1 should be very short like an hour. We was told not to do a refresh prior to the ndmpcopy because that can also cause ndmpcopy to do a full backup and restore. Any help is appreciated.
No Events found!
Rainer_EMC
4 Operator
•
8.6K Posts
0
November 5th, 2012 08:00
Did you do a regular NDMP backup in between ?
Have you looked at the data mover log for messages ?
dhankins1
5 Posts
0
November 5th, 2012 08:00
No we haven't done a regular NDMP backup in between. Yes, I've looked at the data mover log but it's not very helpful. Also, what would I be looking for in the messages? Will it say something about ndmpcopy? The NDMPcopy will eventually finish just don't know when, but it's just taking to long.
umichklewis
3 Apprentice
•
1.2K Posts
0
November 5th, 2012 10:00
Have you tried elevating the NDMP logging from the control station? Here's a pretty old thread to help turn it on:
https://community.emc.com/message/576552
Let us know if that helps!
Karl