Unsolved
This post is more than 5 years old
1 Message
0
700
September 17th, 2012 14:00
Multi-pathing on Celerra NX4
We are currently running a VMware enviroment attached through iSCSI to a Celerra NX4. Does the NX4 support multi-pathing on the data movers or they simply only setup to run master/slave? We want to set up for redundancy as well as performance. We've been able to get a Dell PowerVault to scream with this method. We currently have two VMware servers connected to two iSCSI switches and then on to two ports on the Celerra. Does anyone have any input on this deployment method? Thanks in advance.
No Events found!
bergec
275 Posts
0
September 19th, 2012 03:00
That Primus suggests to do a copy at the qtree level
Is that something you can do ?
Claude
bergec
275 Posts
0
September 19th, 2012 03:00
Sorry
I replied to the wrong message !
Claude
SAMEERK1
296 Posts
0
September 19th, 2012 03:00
Celerra iSCSI LUNs cannot trespass between data movers, data movers are active/standby configuration and the iSCSI lun is taken over by the other DM only when primary fails over to standby.