This post is more than 5 years old
16 Posts
0
923
May 19th, 2011 08:00
iSCSI and Celerra
I am trying to present Celerra storage via iSCSI to external hosts via 10 G IP network. I am running into an issue of iSCSI LUN size limitations of 2 TB. Is there a way to exceed this limitation without introducing more space without adding additional LUNs?
No Events found!
Rainer_EMC
4 Operator
•
8.6K Posts
0
May 20th, 2011 06:00
If it was purchased as CX4-480 then it typically would have Clariion ISCSI ports
If it was purchased built-in to a NS-480 it won’t – unless explicitly ordered
Rainer
Rainer_EMC
4 Operator
•
8.6K Posts
0
May 19th, 2011 09:00
Or use Clariion based ISCSI
robertkalinowsk
16 Posts
0
May 19th, 2011 09:00
Too Bad. Thanks for the quick reply though.
dynamox
9 Legend
•
20.4K Posts
0
May 19th, 2011 09:00
unfortunatelly no, Celerra is still limited to 2TB limit for iSCSI. If you have iSCSI ports on the SPs ..you could present more than 2TB LUNs
robertkalinowsk
16 Posts
0
May 19th, 2011 10:00
What configuration is required to enable iSCSI on Clariion? Is there additional hardware, software, licensing needed?
dynamox
9 Legend
•
20.4K Posts
0
May 19th, 2011 10:00
you have to have iSCSI ports on the SPs ..what model is your array ?
dynamox
9 Legend
•
20.4K Posts
0
May 19th, 2011 10:00
i believe that model comes with iSCSI ports, you should see them in Navisphere
robertkalinowsk
16 Posts
0
May 19th, 2011 10:00
No. Slots are empty. Only Fibre connection is present
robertkalinowsk
16 Posts
0
May 19th, 2011 10:00
CX4-480
dynamox
9 Legend
•
20.4K Posts
0
May 19th, 2011 11:00
bummer ..must be stand-alone CX4 only.