This post is more than 5 years old
19 Posts
0
859
July 14th, 2011 20:00
How can I provision nlsas disks on vnx 5300 system?
Hello.
I can´t provision nlsas disks for file system, I have only 6 nlsas 2tb disks, but CSA doesn’t allow me to choose them.
Is there another way to configure on a VNX 5300 system?
No Events found!
avs
1 Rookie
•
91 Posts
0
July 21st, 2011 23:00
Hello
1. Create R6 4+2 RG
2. Create two LUNs on RG with different SP owner
3. Add them to Celerra SG with HostID greater then 16
4. Go to CS by ssh as nasadmin
5. Issue "nas_diskmark -mark -all" command and wait for a while
6. Check new dvols were added to Celerra by using "nas_disk -l"
7. Then you can add dvols to manually created pool or leave it in system pool
Alex
Rainer_EMC
4 Operator
•
8.6K Posts
0
July 15th, 2011 01:00
See Powerlink Celerra tools on how to create the RGs and LUNs manually
avs
1 Rookie
•
91 Posts
0
July 16th, 2011 06:00
Hello
Take a look at "Managing Volumes and File Systems on VNX™ Manually" document.
It's located Home > Support > Technical Documentation and Advisories > Hardware/Platforms Documentation > VNX Series > General Reference
For 6 nlsas disks you can only use R6 4+2
Best regards,
Alex
LECORRE_Julien
3 Posts
0
July 18th, 2011 05:00
If i remember you have to select "protection" for your RAID Configuration under the VSA in order to have a R6 4+2
Perseo_37bdd2
19 Posts
0
July 21st, 2011 20:00
Thank you for your answer, I read the documents, but my problem is I can't asign disks, all time appear message, disk can't provisioning, this appear with CSA tool, when I tried to provisioning manually, disc doesn't appear elegibles.
Just a can see them if a configure by block, but I need for file system.
Any other recomendation?