Unsolved
This post is more than 5 years old
1 Message
0
565
November 8th, 2012 03:00
Celerra NX40 - power LED on the front fault
Hello,
I turned on the Celerra and the power LED on the front of the blade enclosure are two in orange.
For the 4 leds on the front, the second and the fourth are in orange, can you tell me what is going wrong?
If I connect to CS via serial and I make a:
/nasmcd / sbin / getreason out:
10 - slot_0 primary Control Station
0-slot_2_reset
0 - slot_3 _reset
Can you tell me something?
Many thanks in advanced.
No Events found!
jithin
91 Posts
0
November 27th, 2012 03:00
Hi,
The datamovers are in reset state and seems to be rebooting. Please check if you are able to communicate with the backend storage SP's from control station.
Jithin
BillStein-Dell
Moderator
•
285 Posts
0
November 29th, 2012 09:00
Hi
If the Data Movers are still in this state and you haven't yet opened a Service Request or started a Chat with Support, I would suggest you do that.