Unsolved
This post is more than 5 years old
1 Message
0
382
May 5th, 2014 07:00
Celerra NS-480 back-end connectivity problems.
Good day.
I'm currently setting up a tape library to backup the data from the Celerra but I only have AUX0 ports available on each DM.
The question is, can I connect the DMs to the SPs through a FC switch?
Is this configuration supported?
Is it a must for them to be directly connected?
I'm using 2 Cisco MDS 9148 switches for redundancy purposes.
Thanks for your help.
No Events found!
Rainer_EMC
4 Operator
•
8.6K Posts
0
May 5th, 2014 11:00
No - the connections between DM and SP have to be direct - these are for disks only - no tapes there
For tape drives you need to use the AUX ports on the data mover - there you can connect to a FC switch