Can't figure out when to use CSA

Hello everyone,

I recently got a used Celerra NS120 system with a single blade, but two disk enclosures.

I have cabled everything according to the installation guide and re-installed the Control Station Linux on the CS. I had to do that, because the person I bought it from can't tell me the passwords, etc.

The CS is currently sitting in the screen saying "Is this a Control Station Fresh Install?". This is the first one it shows after it rebooted to finish the installation. I assumed this was the correct screen, since I have to use CSA right after the installation?

Now when I try to run CSA, it says "ERROR:Celerra not found". I have tried attaching the windows client directly to the LAN-Port labled MGMT, and also tried when both were connected to a switch. I have also tried different clients and disabled other ethernet-ports on both. Windows-Firewall on both clients was disabled too (I don't use any other firewall on my clients).

Am I doing something wrong here?

I am completely new to this whole topic, so please excuse any stupid mistakes.

Any help will be appreciated!

Thanks in advance!